logoww01.gif (53633 bytes)

 key.gif (3394 bytes)

how.jpg (32185 bytes)

twist.jpg (8864 bytes)

How do you use WUN WAC?
show01.jpg (61777 bytes)

First secure the first plank by nailing through the rear surface into the joists using either nails, or a nail gun, or screws. A nail gun is fastest.
show01.jpg (61777 bytes) Next you have to nail down the front. The nails are placed at 45 degrees just below the key way. Nail in flush to the wood surface.
show01.jpg (61777 bytes) Position the next plank allowing enough space to insert the keys.
show01.jpg (61777 bytes) Insert the Wun Wac keys keal down wedging into both board's key ways.
show01.jpg (61777 bytes) Hammer the planks together carefully without wood surface damage. A board in front of your hammer helps to avoid surface damage to the planks.
show01.jpg (61777 bytes) You have two planks secured. Repeat the process until all planks are secured.